iii
When using the Genie fork lift you must first attach the two lift-clamp assemblies
to either side of the module. Unscrew the securing screw that holds the telescopic
section of the lift-clamp closed. Insert the rear locating pins into the holes at the
rear edge of the module (the open end of the box section should face the front of
the module). Align the front locating pins with the holes at the front of the mod-
ule and tighten the holding screw.
Locate the forks of the Genie lift into the two box sections in the lift clamps.
Raise the module by turning clockwise the handle on the Genie lift. Lower the
module by turning the handle anti-clockwise.
Warning – Your attention is drawn to the operating instructions for the Ge-
nie lift that ar e supplied by the lift’ s manufactur ers.
•
Genie fork lift, part number 73-FORK-GENIE.
•
Module lifting gear, part number 65-MODULELIFT
Содержание Computing Surface CS-2
