Meggitt Fuelling Products
Maintenance Manual (MMF145)
Pressure Fuelling Nozzle
–
F145 Series
USE OR DISCLOSURE OF DATA ON THIS PAGE IS SUBJECT TO THE RESTRICTIONS ON THE TITLE PAGE OF THIS DOCUMENT
05 Jan 2015
Revision 6.4
33
30. (
Nozzle with TEO26383, or “Rev
R
” and subsequent revision letter
) Inspect ball race (98) for
damage and replace as necessary. Install ball race (98) into nozzle body (1A).
31. Install spring (55) in nozzle body (1, 1A).
32. Insert specified mod (Mods: G1, H1, L1, N1, P, 3 thru 9) into inlet of nozzle body (
IPL Figure
1
,
1, 1A).
33. Inspect bearings (43) for damage and replace as necessary. Put bearings (43) in ball tool
(T-90465). The last ball bearing should fit to edge of tool opening. If the ball bearing is
significantly below this edge, there are missing ball bearings.
34. At opening of screw (46) location; insert ball tool (T-90465) with captured bearings (43) and fill
nozzle body (1, 1A) with bearing (43).
35. Apply petroleum jelly to new O-ring (45) and put onto nozzle body (1, 1A). Install screw (46)
and torque to 120 ±5 in-lbs (13.5 ±0.6 N,m).
36. (Mods: G1, H1, L1, N1, P, 3 thru 7) Install screws (72), washers (73 and 74) and valve
assembly (70) or coupling assembly (81, 82) into adapter swivel assembly (71).
37. Use safety cable (54) or safety wire (58) to secure all torqued screws.
38. Connect dust cover assembly (53).
Note:
If dust cover assembly was removed; install bolt (48), washers (22 and 22A) and
nut
(23) to dust cover assembly‟s cable
.
39. If pipe plug (10) was removed from nozzle body (1, 1A) do as follows:
a. Make sure pipe plug (10) threads and nozzle body (1, 1A) threads are clean and free from
debris.
b. Apply anti-seize tape (PTFE) or equivalent thread sealant to the threads of pipe plug (10);
make sure to apply at least 2 to 2.5 turns, but no more of tape.
c. Install pipe plug (10) into nozzle body (1, 1A) and hand tighten, then torque plug (10)
218 ±2 in-lbs (24.6 ±0.2 N,m).
