Megger PFL22M1500 Series, Руководство пользователя

Страница: 65 / 78

AVTMPFL22M Rev 1 April 2011
55
In the event of any of the protection circuits operating use the following
procedures:
1. Remove batteries cables from the batteries, short together and then re-
connect the PFL to the batteries.
In the event this does not work, it is highly likely that the GFCI protection has
tripped
2. GFCI tripped: To re-set the GFCI control take a long screwdriver and push
the reset button which is accessed through the bole in the side of the PFL’s
wheel kit.
3. Low Battery alarm: Turn-off the unit, replace or re-charge batteries
4. Low Battery shutdown: If the voltage has recovered above 11.5V the unit
will switch on.
If it doesn’t recover, after five minutes the system will shut down.
Replace or re-charge batteries up to correct operating voltage
5. High Battery shutdown: If the voltage falls to below 15.5V the unit will
switch on.
If it doesn’t recover, after five minutes the system will shut down.
Use batteries of correct rating.
6. AC Output overload: Shuts down the inverter automatically if a short
circuit occurs or if the load exceeds the operating limits.
Remove batteries cables from either the batteries or PFL and re-connect
7. Over temperature: Allow the unit to cool down and re-energise. If after five
minutes of operating in high temperature, the unit turns itself off.