12
Test Frequency
Default testing frequency is 1KHz. Push "
FREQ
" key to select
the desired test frequency.
L/C/R Function Selector
Press "
L/C/R
" pushbutton to select the desired L, C or R
function.
Relative
Press the "
REL
" key to enter the relative mode and store the
display reading as a reference value. It will then display all
subsequent readings relative to the reference value. Press
"
REL
" button again to exit the relative mode.
Notes:
1. The relative mode can not be activated if the display value
is either "
OL
" or "
0000
".
2. Relative mode is only available in manual ranging;
however, activation while in auto-ranging will automatically
set the meter to manual ranging and cause calibration
prompts to be displayed in the relevant ranges.
3. The relative mode cannot be activated if the meter is set at
auto-ranging with data hold activated.
Tolerance
There are 1%, 5% and 10% tolerance range. To enter this
tolerance mode, insert the appropriate component as a
standard value into the socket or connect the component to
the test probes, then press the "
TOL
" pushbutton to set this
value, as the standard reference tolerance. Similarly, any
value which appears on the LCD display, such as
DH
or
MAX/MIN/AVG
, can be used as a standard value to sort
components. Press this button again to cycle through 1%,
5% and 10% tolerance as required.
This function is designed for convenient component sorting.
An audible tone of “Be-Be-Be” will sound whenever the
component under test exceeds the setting tolerance.
Conversely, a single tone of “Be” indicates the component is
within the setting tolerance.
