4
IMPORTANT
READ THESE INSTRUCTIONS CAREFULLY AND NOTE THE SAFETY INSTRUCTIONS AND WARNINGS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
FAILURE TO DO SO MAY CAUSE DAMAGE TO PROPERTY AND/OR SERIOUS PERSONAL INJURY.
KEEP THIS INSTRUCTION MANUAL SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS AND WARNINGS
1.
Read and understand all warnings and instructions before use.
2.
Do not exceed the rated capacity. This lift is rated for a maximum of 500kg loads. Overloading may cause
damage to or failure of the lift.
3.
This is a lifting device only.
4.
Keep children and unauthorized persons away from the work area.
5.
Do not operate the lift on inclined or uneven surfaces. The lift must only be used on hard and level sur-
faces which are capable of sustaining the load.
6.
Lift only on areas of the vehicle as specified by the vehicle manufacturer.
7.
Use tie down straps to secure load to the tie-down loops of the lift.
8.
Do not lean on the motorcycle.
9.
Do not move or dolly the vehicle while on the lift.
10.
Before moving, lower the load to the lowest possible point.
11.
Exercise special caution during working, especially during lifting and lowering in order to prevent the mo-
torcycle from falling.
12.
Use the safety lock when load is raised to prevent accidental lowering.
13.
Never go or work under a raised load.
14.
Before lowering the lift ensure that there are no obstructions underneath and that all persons are standing
clear. Safety distance is about 2,5m during lifting and lowering.
15.
No alterations shall be made to this product.
2. TECHNICAL DATA
Max. capacity
500 kg
Min. height
130 mm
Max. height
430 mm
3. ASSEMBLY
1.
Place the hydraulic ram (I) onto the base (A) using two M8x25 hex bolts (S), two spring washers (Q) and
two washers (T), and using M6x15 bolt (U) to fix the ram to the connecting rod (E), then tighten.
2.
Insert the foot pedal (J) to the hydraulic ram (I) and secure using M8x25 bolt (S).
3.
Place the safety lock operating rod (D) to the safety lock (N) using two spring washers (Q) and two nuts
(R).
4.
Insert the handle (F) to the connecting rod (E) and secure using M8x25 bolt (S).
4. OPERATING INSTRUCTIONS
To raise
1.
Place the lift on a hard and level surface.
2.
Locate the center of the weight load and position the lift under the load so that the saddles are positioned
in the center of the weight load. This will ensure best balance and safe lifting.
3.
Pump the foot pedal up and down until the saddles contact the load, then check to assure the saddles and
the weight are positioned correctly before raising.
4.
Use tie down straps to secure the load to the jack and tighten the straps.
5.
Stabilize the lift by adjusting the locking screws (G) to the ground for a firm balance.
GB
