Megamaster 720-0804C, Инструкции по сборке и эксплуатации

Страница: 30 / 37

MAIN BURNERS
FLAME CHARACTERISTICS
1. Check for proper burner flame characteristics.
2. Burner flames should be blue and stable with no yellow tips, excessive noise, or lifting. If any
of these conditions exist call our customer service line. If the flame is yellow, this is a
indication of insufficient air. If the flame is noisy and tends to lift away from the burner, this is
a indication of excessive oxygen.
3. Visually check the burner flames prior to each use, The flames should look like the image
below. If they do not, refer to the burner maintenance part of this manual.
KNOB OPERATION
30
NOTE: Each burner is adjusted prior to shipment; however, variations in the
local gas supply may make minor adjustments necessary. Oxygen setting
can be adjusted by using the screw located on the top of the burner near the
orifice connection . Turn the screw using a star-screwdriver until the flame
quality is acceptable .
Open lid during lighting.
Make sure all the knobs are in the “OFF” position, and
then turn the Liquid Propane Cylinder valve “ON” by
slowly turning counterclockwise.
Push and turn Main Burner control knob to IGNITE/HIGH
or IGNITE/ON, at the same time, press and hold control
knob to light the burner, with the electronic ignition.
Once the burner is lit, release the knob.
If ignition does not occur in 5 seconds, turn the knob to
OFF, wait 5 minutes and repeat the lighting procedure.
IGNITION INSTRUCTIONS
2
3
4
5
1
2
3
4
5