MEFE—Mitchell Engineering Food Equipment Pty Ltd
23 Storie Street Clontarf QLD 4019 Australia
www.mefe.com.au | [email protected]
Page 3
+617 3283 4536
Free AU 1800 669 006
1. General Safety Guidelines
Before Using This Power Tool
•
Always wear hand protection.
•
Keep bystanders out of the work area while operating the tool.
•
Wheel guards and eye shields must be properly adjusted and tightened.
•
Always make sure wheels are properly mounted and tension is properly applied.
•
Stand to the side of the bandsaw during start
-
up. Switch it on and let the band operate at full speed for approximately one
minute so that any undetected flaws or cracks will become apparent.
•
Keep guides in place and working properly.
•
Keep hands clear of blade wheels.
•
Never reach behind or beneath the saw—never reach into or over the table.
•
Disconnect power before changing blade or performing any cleaning. Always allow wheels to stop before adjusting or ser-
vicing. Do not stop the wheels with your hands or work piece.
•
To avoid electric shock, DO NOT spray direct into motor or submerge machine in water.
•
Use only accessories that are recommended by the manufacturer of your model.
•
Always check blade is tensioned correctly.
•
Grounded tools must be plugged into an outlet that has been properly installed and grounded in accordance with all local
codes and standards. Never remove the grounding prong from the plug or modify it in any way.
•
Do not use adapter plugs. If in doubt as to whether the outlet is properly grounded, consult a qualified electrician.
•
Do not use the tool when tired or under the influence of drugs, alcohol or medication.
•
Do not wear loose clothing, gloves or jewellery; tie up long hair and button all long sleeve shirts.
•
Ensure the power switch is off prior to plugging in the tool.
•
Do not over tighten spindle nuts.
•
Service on these tools should only be performed by an authorized, qualified technician.
1.1 Additional Specific Safety Rules
1.
DO NOT operate this machine until it is completely assembled and installed according to the instructions. A machine
incorrectly assembled can cause serious injury.
2.
OBTAIN ADVICE from your supervisor, instructor, or another qualified person if you are not thoroughly familiar with the
operation of this machine. Knowledge is safety.
3.
FOLLOW ALL WIRING CODES and recommended electrical connections to prevent shock or electrocution.
4.
USE ONLY blades suitable for the product being cut and for the speed of the machine. Unsuitable blades can cause damage
5.
DO NOT over tighten wheel nut.
