Meech 976EX, Руководство по эксплуатации

Страница: 8 / 20

6
POWER, INPUT AND OUTPUT (I/O) WIRING MUST BE IN ACCORDANCE WITH
CLASS 1, DIVISION 2 WIRING METHODS ARTICLE 501.10(b) OF THE NATIONAL
ELECTRICAL CODE , NFPA 70.
A) THIS EQUIPMENT IS SUITABLE FOR USE IN CLASS 1, DIVISION 2,
GROUP D OR NON HAZARDOUS LOCATIONS ONLY
B) WARNING - EXPLOSION HAZARD - SUBSTITUTION OF COMPONENTS MAY
IMPAIR SUITABILITY FOR CLASS 1, DIVISION 2
C) WARNING - EXPLOSION HAZARD - DO NOT DISCONNECT EQUIPMENT
UNLESS POWER HAS BEEN SWITCHED OFF OR THE AREA IS KNOWN TO
BE NON-HAZARDOUS.
Connect the mains supply to the Pulsed DC Controller and switch ON. The 976EX Bar
will now produce Pulsed DC ionisation from the emitters of the Bar.
The shockless emitter pins produce ions of positive and negative polarity. These,
because of the product’s unique design, propel themselves away from the emitter
points towards the target area.
Optimum static elimination can be achieved by adjustment of the “Rate” (frequency of
pulsing) and the “Balance” ( proportion of positive to negative ions generated) on the
Controller.