Meec tools 011254, Руководство по эксплуатации

Страница: 45 / 47

EN
45
CLEANING
Wipe the product with a damp cloth after use.
CHECKING AND CALIBRATING
THE FENCE
The fence holds the workpiece fixed in place,
while the table and/or blade is set to the
required mitre angle and/or bevel angle.
For accurate sawing the fence must be at
right angles (90°) to the blade.
1. Saw a spare piece with the saw table set
to 90°.
2. Check the cut with a set square.
The angle can also be checked by turning
one piece 180° and pressing the sawn
edges together.
3. Adjust the fence if the cut is not at 90°.
ADJUSTING THE FENCE
1. Bring down the saw head and lock it with
the lock pin.
2. Place a set square on the table with one
side against the blade and the other
against the fence. Any deviation will be
clearly visible. NOTE: The set square must
be flush with the side of the blade, not
against the teeth, for a correct reading.
3. The fence is fixed with a screw in each
end. Undo the screws a little and carefully
tap the fence to the correct position with
a rubber mallet. Tighten the screws and
check by sawing another spare piece.
Repeat until the fence is correctly adjusted.
4. Firmly tighten the screws. Continue with
the work after the test sawing.
CALIBRATION OF MITRE ANGLE
SCALE
When the fence angle has been checked and if
necessary adjusted at 90° to the blade, check
that the mitre angle scale is set correctly.
marking with the width of the blade on the
piece to be cut off.
5. Secure the workpiece with the clamp.
Check that the workpiece is horizontal and
supported, when necessary med roller
supports or the equivalent.
6. Grip the saw handle, press the power
switch lock with your thumb and press
the power switch to start the product and
activate the saw line laser.
NOTE:
If the saw line laser is not in line with the saw
line marking, release the power switch and
move the workpiece before sawing.
7. Press down gently to saw.
– For thin workpieces, press straight
down to saw off the workpiece
without moving the saw head.
– For wide workpieces, move the blade
over the workpiece when sawing.
Do not press down hard with the
handle. Release the power switch if
the blade jams in the cut.
8. When the sawing is finished, bring up
the saw head, release the power switch
and wait until all moving parts have
completely stopped. Release the clamp
and remove the workpiece from the
product.
9. Switch off the product and pull out
the plug after use. Clean the product
and store it indoors out of the reach of
children.
MAINTENANCE
WARNING!
Switch off the product and pull out the plug
before cleaning and maintenance.