EN
43
and fit the new blade. Check that the arrow
on the blade points in the same direction as
the arrow on the top guard.
8. Replace the outer flange (B) and tighten
the spindle screw (17). Put the flange with
domed side against the blade. Keep the
spindle lock button pressed in and tighten
the spindle screw anticlockwise. Release
the spindle lock button.
9. Turn back the pivot plate and lock it with
the guard pivot.
WARNING!
Check before use that the bottom guard
moves easily and covers the blade.
USING THE TABLE EXTENSIONS
1. Put the table extensions (10) on each side
of the table and lock in place with the
thumbscrews.
2. The top of the table extensions should be
level with the surface of the saw table and
provide more space for the workpiece to
rest on.
3. Support the workpiece so that it is level
with the saw table and so that the sawn
off parts do not drop down. Support long
workpieces with roller supports, or the
equivalent (sold separately).
4. If the workpiece is not horizontal the cut
will be bevelled.
Large workpieces that are not supported
increase the risk of the blade jamming and
causing kickback, which increases the risk of
serious personal injury.
ADJUSTING THE MITRE ANGLE
Mitre sawing involves vertical sawing at the
required angle in the horizontal plane. A mitre
angle of 45° is used to join two pieces at right
angles. A mitre angle of 30° is used for scarf
joints or bevelled ends.
USE
WARNING!
• Avoid accidental starting. Switch off the
product and pull out the plug before
carrying out any of the measures in this
section.
• Always check that the product is in good
condition before use. Check that all
screw unions are tight, that moving
parts are correctly adjusted and can
move freely, that no parts are incorrectly
fitted or defective, that no wires are
damaged, and that there are no other
factors that could affect functionality.
• Do not use the product if the guards
or covers are missing or damaged.
The guards must be able to move freely
and should be closed immediately.
CHANGING THE BLADE
1.
Switch off the product and pull out the plug.
2. Move the bottom blade guard up out of
the way and keep it there.
3. Release the pivot on the guard to release
the pivot plate.
4. Swing the pivot plate up out of the way.
5. Press in the spindle lock button on the
back of the saw head.
6. Remove the spindle screw (17) and the
outer flange.
FIG. 5
IMPORTANT:
• The spindle screw has left-hand thread
and screws out clockwise.
• Make sure that the inner flange (E)
remains on the spindle.
FIG. 6
7. Remove the blade (D) and centre hole insert
(C). Put the centre hole insert in a new blade
Содержание 011254
Страница 4: ...1 3 7 8 9 10 12 13 14 15 16 11 6 4 5 2 1 13 ...
Страница 5: ...4 2 5 3 6 17 17 18 A B C D E ...
Страница 6: ...7 8 1 2 1 2 3 ...
