Meec tools 011229, Руководство по эксплуатации

Страница: 46 / 99

46
2022_001
● Do not use damaged, defective or deformed batteries. Do
not open the battery.
● Do not charge the battery near acid and/or flammable
gas.
● Do not expose the battery to heat or fire.
● Do not charge the battery at temperatures lower than
10 °C or higher than 40 °C, that can damage the battery.
● Do not expose the battery to high temperatures or strong
sunlight.
● The battery will get hot during use. Let the battery
become cool before charging.
● Do not short-circuit the battery terminals.
2.14 Safety instructions for
maintenance
Warning! If you do not obey these instructions, there
is a risk of death or injury.
● Stop the product and disconnect the battery before you
do maintenance of the product.
● Let an authorized service center do the repair of the
product. The warranty will be invalidated if the product is
modified in any way, damaged as a result of an accident,
negligence or incorrect use, or if it has been repaired by
unauthorized personnel.
● Only use spare parts recommended by the manufacturer.
Install the spare parts according to the manufacturer’s
instructions.
● Follow the instructions for lubrication, tensioning the
chain, and replacing accessories. The wrong tension
and/or lubrication of the chain can result in a risk of the
chain breaking and/or kickback.
2.15 Vibration safety
Warning! If you do not obey these instructions, there
is a risk of death or injury.
● There is a risk of personal injury as a result of vibration
during prolonged and/or incorrect use.
● The actual vibration level when you use power tools may
differ from the specified maximum value, depending on
how the tool is used. It is therefore necessary to
determine which safety precautions are required to
protect the user, based on an estimate of exposure in
actual operating conditions (taking into account all
stages of the work cycle, e.g. the time when the tool is
switched off and when it is idling, in addition to the
start-up time).
● During prolonged use vibrations are suspected to cause
circulation problems in the hands and arms, or Raynaud’s
syndrome (white fingers). Stop working immediately and
seek medical attention if you experience numbness,
itching, tingling or pain, or if your skin changes colour.
Limit the risk of injuries as a result of vibrations by
maintaining the tool correctly, keeping your hands warm
and taking breaks.
3 Assembly
Warning! Wear safety gloves when assemble the
product.
Note! Do not install the battery before the product is fully
assembled and adjusted.
● Unpack the product and make sure that all parts are
included and not damaged.
3.1 To assemble the bar and the chain
Warning! The chain is sharp. Always wear safety
gloves when you do maintenance on the chain.
Warning! Make sure to install the chain correctly.
Make sure to install the chain in the correct direction of
rotation.
Warning! Always make sure to stop the product,
remove the battery and apply the chain brake before you do
a check on the chain tension.
1
Put the product on a level surface.
2
Release the locking knob for chain guard. (Figure 3)
3
Remove the chain guard. (Figure 4)
4
Turn the chain tensioner clockwise (A) to move the
bar close to the sprocket (B).
5
Install the chain.
A. Make sure to install the chain in the correct
direction of rotation. Refer to marks on the chain
(C).
B. Put the chain on the top of the bar.
C. Put the chain in the slot of the bar.
6
Put the bar on the pin screw on the product. Put the
chain round the sprocket. (Figure 5)