Meec tools 008121, Руководство по эксплуатации

Страница: 31 / 32

EN
5
try again. If the log still does not split, discard it.
Logs should be split along the length of the
grain. Never attempt to split a log across
the grain with the product: risk of personal
injury and/or serious material damage. Never
attempt to split two or more logs at the same
time. One of them could be thrown out and
cause personal injury and/or material damage.
NOTE:
Always place logs firms on the workbench
with the log support. Position the log so that
it cannot twist, wobble or slide away during
the splitting. Do not put the log on the top
part of the blade. This can damage the blade
and/or the log splitter.
RELEASING JAMMED LOG
1. Release both controls.
2. When the piston has gone back and
stopped in the home position, place a
wooden wedge under jammed log.
FIG. 8
3. Run the piston so that the wedge is
pressed in under the jammed log.
4. Repeat with thicker wedges until the log
comes loose.
NOTE:
Never attempt to knock or tap a jammed log
loose. This can damage the log splitter, or
cause the log to suddenly come loose and
cause personal injury.
FIG. 9
MAINTENANCE
CHANGING THE HYDRAULIC OIL
The hydraulic oil in the log splitter should be
changed after an interval of 150 working hours.
Follow the instructions below:
1. Switch off the engine and wait until all
moving parts have completely stopped.
2. Unscrew and remove the oil drain plug
with dipstick.
3. Tip up the log splitter on the support legs
and let the oil run out into a container
that holds at least 4 litres.
FIG. 10
4. Tip up the log splitter on the support legs.
5. Fill up with new hydraulic oil. The volume
is specified in Technical data.
FIG. 11
6. Stand the log splitter up. Clean the
dipstick and the plug and replace them in
the tank.
7. Take out the dipstick and check that the
oil level is between the marks on the
dipstick.
8. Check that no oil is leaking out.
IMPORTANT:
Check at regular intervals that the oil level is
between the two markings on the dipstick.
Top up the hydraulic oil if the level is too low.