Medora SolarBee SB10000PW, Руководство пользователя

Страница: 19 / 36

18
Distance Between Distributor Dish And Water Level
Dish Depths For Different
Models of SolarBees
SB10000
SB5000
SB2500
WATER LEVEL NOTCH
SETTING FOR:
Distributor Dish Level Setting
The SolarBee distribuitor dish depth in the
water is a key factor in maintaining the near-
laminar flow of water coming off the machine.
The distributor dish level setting is measured
from the top lip of the dish up to the water
surface. For this SB10000PW , the depth
level should fall on or between this range:
2.0 inches to 2.5 inches (5.0 cm - 6.5 cm)
Distribution Dish Level Adjustment
TOOLS RECOMMENDED:
Tape Measure
STEP 1: If SolarBee is not on, turn the On/Off
switch to the On position.
STEP 2: Observe if the dish level is too deep
or not deep enough at the three locations
where each float arm extends out from the
machine. This can be done using a tape
measure, by approximating the height of a
nickel, or locating the notch on each chain
bracket for machines having a hose. If using
the notch on each chain bracket, the water
level should be even with the appropriate
notch (see picture).
STEP 3: Set the dish to the correct level in
each of the three locations. To raise the dish
level, rotate the turnbuckle around (clockwise)
so that it is expanding. To lower the dish
level, rotate the turnbuckle around (counter-
clockwise) so that it is compressing.
STEP 4: Double check dish level at all three
locations and fine tune as necessary.
Maintenance and Field Adjustment
Water Level Even With Notch On Chain Bracket
Turnbuckle Handle
Chain Bracket
Notch
2-in to 2.5- in (5.0 cm - 6.5 cm)
Dish Level
Water Level