Medora SolarBee SB10000PW, Руководство пользователя

Страница: 28 / 36

27
Blink Indication Follow-up Procedures
Blinking Green - System healthy, machine
should be operating on programmed run
schedule. If not operating on programmed run
schedule, contact SolarBee Customer Service.
1X Blinking Yellow - High motor current, check
the machine for plugging at impeller and/or
strainer-intake.
2X Blinking Yellow - Low battery voltage,
machine may be operating at reduced speed or
temporarily shut down due to cloudy weather
period. Re-check machine after sunlight
conditions improve.
5X Blinking Yellow - Check GPS connection
at Brain-Board (lower right corner). If properly
connected and blink code persists, contact
SolarBee Customer Service.
1X Blinking Red - Anti-Jam Routine, machine is
operating on a jam removal sequence triggered
by high current. Check for plugging only after
disconnecting power. If power is not removed
first, machine may begin to operate
2X Blinking Red - 36 VDC out of range,
machine may be shut down due to blown fuse
(glass cylindrical) on the Zahn Board. Left
side of Zahn board takes a 5 Amp Fuse, Right
side of Zahn board takes a 20 Amp Fuse.
Disconnect power before changing fuses.
Blown fuses may be difficult to observe, so a
continuity tester or new fuse should be used to
confirm that the problem is not a blown fuse.
5X Blinking Red - Battery out of range,
machine battery is too low. Check and record
battery voltage if possible, then contact
SolarBee Customer Service.
For all other blink codes, please contact
SolarBee Customer Service.
5 Amp Fuse 20 Amp Fuse
SolarBee Troubleshooting