Removing and Replacing the Faceplates
Each MLC model is delivered with a faceplate (bezel) attached. This faceplate can be
removed if you want to replace any of the buttons or exchange the faceplate for another.
Replacement kits containing six-button or eight-button faceplates and additional buttons
can be ordered (see
for information on parts that are provided or
available to order for each MLC model).
Removing and replacing an MLC D faceplate
The MLC D models are delivered with a black faceplate attached. If desired, you can
remove this faceplate and replace it with the white one that is also provided with the
product. (Matching black and white Decora wallplates are also provided.)
1.
Remove the faceplate from the MLC D as follows:
At the center top and bottom of the faceplate are tabs, which insert into slots on the
MLC main board and hold the faceplate in place. For each tab:
a.
Insert the flat end of the provided Extron Tweeker or other small screwdriver into
the hole above or below the tab.
b.
Pressing each tab in and up, pry the top and bottom of the faceplate away from
the board (see figure 12).
VOLUME
Extron
DISPLAY
VIDEO
PC
ON
OFF
Figure 12.
Removing the Faceplate (MLC 60 Series D Models)
2.
If you are switching faceplates, transfer the buttons from the faceplate you removed
to the replacement one.
3.
Make any desired button changes (see
on page 23).
4.
To attach the faceplate, make sure that both the faceplate and the MLC board are
upright
and
line up the pegs in upper-left and lower-right corners on the back of the
faceplate with the two diagonal holes on the MLC board.
MLC 60 Series MediaLink Controllers • Features, Installation, and Operation
19