Media5 Mediatrix Sentinel, Руководство по установке оборудования

Страница: 29 / 35

Troubleshooting
Copyright © 2015
29
A partial reset will also modify the following parameters to their default value:
Service Parameter Default Value
Users.Password User(s) from profile are restored
with their factory password.
All other usernames keep their
password.
Users.AccessRights User(s) from profile are restored
with their factory rights.
AAA
ServicesAaaType (table) Each service will be configured to
use Local authentication and no
accounting mechanism.
EnableTelnet Disable
TelnetPort 23
EnableSsh Enable
CLI
SshPort 22
HOC ManagementInterface Lan1
EnableSnmpV1 Disable
EnableSnmpV2 Disable
EnableSnmpV3 Enable
SNMP
Port 161
ServerPort 80
HTTPMode Both
Web
SecureServerPort 443
Performing a Partial Reset
Before you start
To fully understand the changes the partial reset will apply to your configuration, refer to Partial
Reset
(p. 28)
.
It is not recommended to access the unit on a regular basis through the Rescue Network Interface.
Steps
1)
When the Power LED is steady or blinking rapidly, insert a small unbent paper clip into the Reset/
Default switch located at the front of the unit.
The Power LED will start blinking.
2)
Wait a few seconds.
3)
When all LEDs are blinking, but before they stop blinking, remove the paper clip.
You have between 7 to 11 seconds.