Installing a Mediatrix Unit
Copyright © 2015
19
4)
Validate the installation
5)
Turn ON the power sources that are used to power the Mediatrix unit at the circuit breaker.
When the unit is brought from a cold to a warm environment, condensation, that might be
harmful to the unit, may occur. If this is the case, wait one hour before connecting the power
cord.
6)
Turn On the power switch of the Mediatrix.
Please note that Redundant Power Supply units do not have a power switch.
Result
You can now use the 192.168.0.10 IP address to access your unit's management interface.
Using the Mediatrix Unit in the LAN without a DHCP
Before you start
• Your computer must be set to use the 192.168.0.11 private IP address.
• Make sure that your network connection is working.
• Refer to the Hardware Installation Guide for instructions on how to properly install and connect
the telephony card.
Steps
1)
Make sure an adequate earth ground connection has been made between the grounding screw on
the back of the Mediatrix unit and an appropriate grounding point in your site.
Warning
:
Adequate earth grounding connection of the Mediatrix unit is mandatory to avoid
any damage or injuries.
2)
Connect a 10/100/1000 BaseT Ethernet RJ-45 cable into the ETH5/EXT Ethernet connector of the
Mediatrix Sentinel.
3)
Connect the other end of the cable into your PC.
4)
Validate the installation.
5)
Turn ON the power sources that are used to power the Mediatrix unit at the circuit breaker.
When the unit is brought from a cold to a warm environment, condensation, that might be
harmful to the unit, may occur. If this is the case, wait one hour before connecting the power
cord.
6)
Turn On the power switch of the Mediatrix.
Please note that Redundant Power Supply units do not have a power switch.
Result
You can now use the 192.168.0.10 IP address to access your unit's management interface.
Using the Mediatrix unit in the LAN with a DHCP
Before you start
• Make sure that your network connection is working.
