Model M - Mediatrix S7 Series and Mediatrix S7 LP Series
28
•
Add a Local Firewall rule to allow complete access to the Rescue interface.
•
Rollback NAT settings that are not yet applied.
•
Add NAT rule to allow complete access to the Rescue interface.
•
Cancel the changes that were being modified but not yet applied to the configuration.
•
Disable any Network Interface in conflict with the Network Rescue Interface.
•
Configure and enable the Rescue Network Interface to:
•
use the link as the default value used by the Uplink Network Interface
•
set the IP address to 192.168.0.1 and the Network Mask to 255.255.255.0.
•
set the IPv6 link-local address on all network links. The IPv6 link-local address can be found
underneath the unit.
A partial reset will also modify the following parameters and preserve the values below even after
the Rescue interface has been disabled.
Note:
These changes are valid when using a MX profile. If the Mediatrix unit is not using a MX
profile, the default values and therefore the behaviour of the parameters may be different.
media5corp.com
Содержание M - Sentinel 100
Страница 45: ......
