Medema Mini Crosser M1 Cabin, Руководство по обслуживанию

Страница: 20 / 66

Service manual P9-0151-S 20 of 66 Version 1.0.3/2018
Medema Production A/S
Area Component Check and remedy
Steering column Play/wear Check the following:
- Universal joint
- Pins in steering shaft/front fork
- That the aluminium bottom section
of the steering column is firmly
secured to the steering shaft. (*)
Wear/rust on the bearings in the
steering column. Top support bearing.
The bearings in the head tube are
protected by seal rings. If the front
fork is a bit stiff, the seal rings can be
lubricated with a little grease.
(*) On models with an 8 mm bolt
going into the steering shaft from
the aluminium bottom section of
the steering column. The bolt can
work loose if the steering column
is twisted/knocked hard. This can
be remedied by drilling a hole for a
split pin between the steering shaft
and the aluminium section. Contact
Medema Production A/S.
Cables Check that the cables cannot
become trapped or be subjected
to strain when the handlebars are
turned or the steering column is
folded down.
Gas spring Check:
That the gas spring locks the steering
column securely.
Check that there is no play in the
release lever and the bolts/bushes
securing the gas spring.
Key switch / charging
socket
Check that the key switch does not
wobble.
Clean with a damp cloth or
compressed air if dirty. If the contacts
are corroded, clean them with
contact spray or replace the charging
sockets.
Chassis / seat /
covers
Footplate Check the plastic rivets securing the
mat. Fit new ones if necessary.
Seat post Check that it is properly secured and
in good condition.
Chassis / seat /
covers (contd)
Seat Check that:
The release lever locks the seat
properly.
The seat is firmly secured on the seat
frame/plate.
The seat tube is in good condition. If
necessary, lubricate the tube with a
little acid-free grease.
The armrests are in good condition.