Medema Mini Crosser M1 Cabin, Руководство по обслуживанию

Страница: 19 / 66

Service manual P9-0151-S 19 of 66 Version 1.0.3/2018
Medema Production A/S
Area Component Check and remedy
Motor / gear /
brake
(Transaxle)
Wear Check: That the motor runs smoothly
and evenly. If not, the carbon brushes
in the motor usually need to be
replaced. The minimum length of the
brushes is 10mm. See the Spare
Parts Catalogue for replacement.
Check: The rear wheel bearings in
the gear for wear. Lift the rear of the
scooter. Get hold of one wheel at
a time. Lift it up and down to see if
there is any play in the bearings in
the transaxle. If there is, the whole
unit should be replaced.
Power consumption Power consumption on a level road
with a tyre pressure of 2.8 bar and
75-100 kg on the seat:
10 km/h = 12 - 15 A
15 km/h = 17 - 20 A
Measure on one of the battery cables
using a clip-on ammeter.
Brakes and
disengagement
Check function
When the disengagement lever is up:
It must not be possible to push the
scooter.
It must be possible to drive normally
when the scooter is turned on.
When the disengagement lever is
down:
It must be possible to push the
scooter.
The scooter must not be able to
go. Error 9 should appear when the
accelerator is activated.
The brake must be able to hold the
scooter on a 15° (26%) slope with 75
- 100 kg on the seat.
If not, it must be adjusted or
replaced, depending on how much
wear there is.
Braking distance 10 km/h - 2.0 m (9)
15 km/h - 3.5 m (9)
The figures in brackets indicate the
normal braking parameter when the
scooter leaves the factory. It can be
changed with the programming unit
(forward deceleration). See below
for more information. Please note
that the braking distance must not
be longer than specified in order to
comply with official requirements.