Mecal CDA10, Руководство по эксплуатации и обслуживанию

Страница: 18 / 119

CRIMP DATA ANALYZER
CDA10
REV.01
16
1.8 MACHINE MANAGEMENT
Machine management is only allowed to be performed by authorised and appropriately trained
operators, or operators with at least sufficient technical experience.
Operators in charge of machine use and maintenance must be aware that the knowledge and
application of safety regulations is an integral part of their work.
Operators not authorised to work on the machine must not have access to their control panels.
Perform the following operations before starting the machine:
• Read this manual carefully;
• Be familiar with which protections and emergency stop devices are present on the machine,
where they are located and how they work;
Removing or even partially removing the protections, safety devices or monitoring plates affixed on
the machine is prohibited. In the event of malfunction or failure of these devices, immediately
repair or replace them.
1.9 CONDITIONS CHECK
Check that machine has not been damaged during transport. Please therefore report any accidents
or presence of visible damage (signs or traces of impact) as follows:
•
With a written note on the Transport Document.
•
Communicating the damage detected by registered letter to the carrier and to Mecal S.r.l. ,
within 48 hours of receipt of the machine.