Page 46
93924 – September 2015
60-J Diesel
Transport Instructions
Securing the Platform
With the boom completely stowed,
raise the jib slightly, then use the
Platform Level function to lower the
platform until the front of the platform
touches the trailer surface.
Route the tie-down strap as shown
through the width of the platform,
over the toe boards of both side entry
points. Tighten securely but do not
over-tighten.
It may be necessary to turn the platform
90 degrees when loading two machines
on the same trailer. In this case, route
the strap over the toeboard and
through the end of the platform as
shown.
Loading Two Machines
Two machines may be loaded onto a single trailer by rotating the turntable of each machine and
rotating the platforms as shown below.
• Extend the boom of each machine approximately 38 cm.
• Arrange the machines as shown. The distance between the ends of the counterweights
should be 13.4m-13.7m.
• Secure the chassis of each machine as previously instructed on page 43.
• Engage the Rotation Lock of each machine as previously instructed on page 43, using
one of the side turntable locking holes.
• Secure the platform of each machine as previously instructed above.
ART_4744
Strap
Single machine
on trailer
Two machines
on trailer
Strap
Strap
2.59 m
13.4 m
ART_4821