93924 – September 2015
Page 13
60-J Diesel
Controls & Components
CONTROL
DESCRIPTION
1
Hour Meter
Indicates total elapsed time of machine operation.
2
Selector Switch
PLATFORM
Select to operate from the platform control panel.
BASE
Select to operate from the base control panel.
OFF
Select to stop operation from either control panel.
3
Start/Stop Switch
Push switch up to start engine. Push switch down to stop engine.
4
Glow Switch
Press this switch up to activate glow plugs prior to starting.
5
Starter Time-out
Indicator
When this red light is illuminated, the starter circuit is temporarily disabled. The starter circuit times out
if the starter is run continuously for 15 seconds without the engine starting. The starter functions resets
after approximately 30 seconds.
6
Emergency Stop
Switch
Press the EMERGENCY STOP switch at any time to stop all machine functions.
Turn switch
clockwise
to reset
7
Platform Rotate
Switch
Press and hold the Function Enable Switch (#15), then move this switch left to rotate the platform
clockwise.
Press and hold the Function Enable Switch (#15), then move this switch right to rotate the platform
counterclockwise.
8
Platform Level
Switch
Press and hold the Function Enable Switch (#15), then move this switch up to manually level the rear of
the platform upward.
Press and hold the Function Enable Switch (#15), then move this switch down to manually level the rear
of the platform downward.
9
Overload Indicator
Light
Light ON indicates too much weight on the platform.
An audible alarm will sound and all machine function will stop.
Remove weight from the platform to restore function and continue.
10 Tilt Indicator Light This light illuminates and an alarm sounds when the machine is not level. Follow the instructions on page
25 to safely lower the platform.
11
--
--
12 Boom
Extend/Retract
Press and hold the Function Enable Switch (#15), then move this switch right to extend the boom.
Press and hold the Function Enable Switch (#15), then move this switch left to retract the boom.
13 Boom Lift/Lower Press and hold the Function Enable Switch (#15), then move this switch up to lift the boom.
Press and hold the Function Enable Switch (#15), then move this switch down to lower the boom.
14 Turntable Rotate
Press and hold the Function Enable Switch (#15), then move this switch left to rotate the turntable
clockwise.
Press and hold the Function Enable Switch (#15), then move this switch right to rotate the turntable
counterclockwise.
15 Function Enable
Switch
Press and hold this switch to enable boom, turntable and platform operations.
Press down to operate the controls at slow speed.
Press up to operate the controls at higher speed.
16 Jib Lift/Lower
Press and hold the Function Enable Switch (#15), then move this switch up to lift the jib.
Press and hold the Function Enable Switch (#15), then move this switch down to lower the jib.
17 Circuit Breaker
Trips when there is excessive electrical load. Push to reset.
18 Auxiliary Power
Switch
If normal power fails, press and hold while using boom retract and boom lower functions.