Page 11
84RT Seres Speed Level™ - Operator’s Manual
July 2021
Jobsite Inspection
DO NOT operate this machine until you have read and understood the Safety section of this
manual, have performed the Pre-Start Inspection, Routine Maintenance, and Functions Test,
have inspected the jobsite for hazards, and have learned the operating procedures for this
machine�����
Inspect the jobsite and determine whether the jobsite is suitable for safe machine operation. Do this
before moving the machine to the jobsite.
Be aware of changing jobsite conditions, and continue to watch for hazards while operating the
machine.
Operators must comply with employer, job site and governmental rules regarding the use of personal
protective equipment – see “Fall Protection” on page 3.
Workplace Inspection
Check the jobsite where the machine will be used for all possible hazards, including but not limited to:
Drop-offs or holes, including those concealed by water, ice, mud, etc.
Unstable or slippery surfaces
Bumps, surface obstructions and debris
Overhead obstructions and electrical conductors
Hazardous locations and atmospheres
Inadequate surface and support to withstand all load forces imposed by the machine
Wind and weather conditions
The presence of unauthorized personnel
Other possible unsafe conditions
•
•
•
•
•
•
•
•
•
Secton 5 - Jobste & Workplace Inspecton
Jobsite Inspection
