MDT Technologies SCN-RT 6AP.01, Руководство пользователя

Страница: 24 / 51

Technical Manual Temperature Controller SCN ‐ RT1
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
24
4.5.3 Setpoint offset
The following settings are available at the ETS ‐ Software:
Illustration 12: Setpoint offset
The following chart shows the dynamic range for this parameter:
ETS ‐ text Dynamic range
[default value]
comment
Max setpoint offset 0K – 10,0K
[3,0K]
indicates the maximal offset
Max setpoint offset valid for

Comfort

Comfort/Night/Standby
scope of the setpoint offset
Reset setpoint offset after
change of mode

No

Yes
Adjustment, whether a setpoint offset is
still valid after change of operating
mode or not
Send setpoint change

No

Yes
Adjustment, whether a change of mode
should be send or not
Chart 25: Setpoint offset
The setpoint can be changed manual by the setpoint offset without a new parameterization by the
ETS ‐ Software. Therefore, 2 variants are available. On the one hand a new setpoint can be pretended
by the communication object “Setpoint comfort”. On the other hand the adjusted setpoint can be
increased or decreased manual by the communication object “manual setpoint value offset”.
At the read in of a new absolute comfort setpoint, the controller becomes a new basis comfort
setpoint. The new basic comfort setpoint causes also an adaption of the indirect setpoints at the
other operating modes. Through this function it is for example possible to read the actual room
temperature as new basic comfort setpoint in. The settings “max setpoint offset”, “max setpoint
offset valid for” and “Reset setpoint offset after change of mode” are not valid at this variant of
setpoint offset, because the controller becomes a complete new setpoint. Specifying a new value is
possible by calling the object “Setpoint comfort”.