MDT Technologies SCN-P360D3.01, Техническое руководство

Страница: 34 / 43

Technical Manual Presence Detector SCN-P360XX.01
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
Tel.: +49-2263-880 • Fax: +49-2263-4588 • knx@mdt.de • www.mdt.de
34
ETS ‐ Text Dynamic range
[Default value]
Comment
Settings standby/orientation light
Standby/Orientationlight

not used

used
Setting if the light shall stay on
after switching off
Standby setpoint 100 – 750 Lux
[100 Lux]
Value for the standby mode
Standby time

1s – 60min
[15s]
Length of standby mode
Settings lock object
Force control active

Yes

No
activates the force control
Lock object
value = 1

off

on (100%)

no change (hold value)

select value
Adjustment of the action at
activation
Value set
(nur bei „Wert
einstellbar“)
0 ‐ 100%
[0%]
defines the value for active
force control
Lock object
value = 0

off

on (100%)

no change (hold value)

restore previous state
Adjustment of the action at
deactivation
Table 17: Settings Constant light control ‐ 2
The parameters are described below:

Adjustment switching behavior/Regulation
The general settings for the constant level light regulation can be done here.
The parameter “Constant light controlled by” defines whethter the constant light shall be
switched via presence or an external object, which could be connected to push button, etc.
The parameter “Use switch on dimming value” defines the start ‐ up value of the regulation. It
can be calculated directly by the internal calculating routine or power up with a fixed value.
Also the time between powering up and starting calculation can be defined.
The parameter “Brightness value [Lux] for switch on” defines if the regulation shall work with
the parameterized value or the last setpoint, which can be set by a relative or absolute
dimming value or via the scene function.
Further more the regulation can be parameterized with different values for day and night via
the parameter “Use day/night object”.