MDL POWERUP 15HP, Руководство оператора

Страница: 10 / 16

Page 10
1. Check that all safety devices are operational again after each service.
2. Replace damaged parts, especially safety devices, only with genuine
replacements parts since parts not tested and approved by the equipment
manufacturer can cause unforeseeable damage.
3. Repair and maintenance work other than described in this section should
only be carried out by qualified specialists.
5.1 Saw blade change
Directly after cutting the saw blade can be very hot- burning hazard! Let a
hot saw blade cools down. Do not clean the saw blade with combustible
liquids. Risk of injury, even with the blade at standstill. Wear gloves when
changing blades.
When assembling, observe the direction of rotation of saw blade!
1. Loosen 3 bolts fixing the outer blade guard, and remove the outer blade
guard.
2. Hold outer flange with spanner and loosen the nut by spanner.
3. Remove the nut and outer flange from the saw spindle.
4. Take the saw blade off the saw spindle.
5. Clean clamping surfaces of:
- saw spindle;
-Inner flange;
-Saw blade;
-Outer blade flange;
-nut.
Do not use cleaning agents (e.g. To remove resin residue) which
could corrode the light alloy components; this can have an adverse effect on the
machine’s stability.
Do not clean the saw blade with combustible liquids.
6. Install new saw blade, observing the direction of rotation.
Do not use:
- saw blades made of high speed steel (HS or HSS);