20
u
t
4 - UNPACKING
PREPARATION AND UNPACKING
The FLUX stove is delivered complete with all its electrical, mechanical, and hydraulic components after it has been tested in the factory:
Remove the cardboard, supports, and polystyrene that secure the stove to the pallet. At this point, open the two side panels and remove
the two brackets holding the stove. To remove the brackets, undo the two "t" screws between the bracket and the pallet and the two "u"
screws between the bracket and the stove (fig.1).
Attention! Above the stove's packing structure there is a cardboard package containing the lateral sides (2 pieces)
and front parts (3 pieces).
Install the stove in the chosen area, making sure it complies with the requirements. The stove body or unit must always be kept in a vertical
position when handled, and handled using carts only. Pay particular attention to the door and its glass, protecting them from mechanical
knocks that would compromise their integrity.
The product must always be moved with care. If possible, unwrap the stove near the chosen area of installation. The packaging materials
are neither toxic nor harmful, and therefore no particular disposal measures are required.
The product, as indicated in figure 1 consists of a single packaged unit.
After removing all the packaging, check that the stove is complete and not damaged. If in doubt, contact the retailer.
The following documents are provided in the package:
• Plant booklet
• Instruction booklet
• Annex G - Technical test report for thermal plant of less than 35 kW.
• Guarantee
Figure 1 - Packaging
