EN
ELECTRICAL INSTALLATION
Pass the electric cable coming out of the panel into the designed hole on the back of the stove.
The supply includes adhesive clips to be attached to the steel back so that the cable adheres to the back of the product, thanks to the
electric clamps, so that the cable does not remain dangling or cannot be inadvertently pulled.
Before securing the cable with clamps and clips, we recommend opening the panel (as in the operating position) to verify the necessary
elongation of the connection cable for the opening movement. Fix the clips and clamps with the panel in this position.
Don’t tighten the clamps or deform the cable, but let it slide slightly inside the clamp, leaving it a bit loose. The
clamp has the aesthetic purpose of not allowing the cable to protrude and not that of creating a block. In some
cases and/or appliances the cable might not even need to be fixed, leaving it full freedom of movement
Remove the decorative panel according to the manual of the product on which the assembly is being carried out and connect the RJ11
plug (similar to a twisted pair cable) to the specific connector on the board (see picture).
The appliance can only be powered on when the mechanical and electrical installation has been performed.
Technical Dept. - All rights reserved - Reproduction is prohibited
4-INSTALLATION
31
