McQuay RoofPak RAH 047C, Руководство по установке и обслуживанию

Страница: 102 / 122

McQuay IM 487-4 99
Check, Test, and Start Procedures
9
Before starting the drive, make sure that all keys are in
place and all setscrews and all capscrews are tight. Check
and retighten all screws and re-tension the belts after
approximately 24 hours of operation.
MVP Variable Pitch Sheaves
Adjusting:
1
Slack off belt tension by moving the motor toward the
driven shaft until the belts are free from the grooves. For
easiest adjustment, remove the belts.
2
Loosen both locking screws A in outer locking ring, but do
not remove them from the sheave. There is a gap of
approximately 1/2" (1 mm) between the inner and outer
locking rings. This gap must be maintained for satisfactory
locking of the sheave.
If locking screws
A are removed by accident and the gap is
lost, screw the outer locking ring down until it touches the
inner locking ring. Then back off the outer ring 1/2 to
3/4 turn until the inner and outer ring screw holes line up.
Reinsert locking screws
A
, but do not tighten them until
after adjustment is made.
3
Adjust the sheave to the desired pitch diameter by turning
the outer locking ring with a spanner wrench. Any pitch
diameter can be obtained within the sheave range. One
complete turn of the outer locking ring will result in a
0.233" (6 mm) change in pitch diameter.]
Do not open
A-B
sheaves more than four 3/4 turns for
A
belts or 6 turns
for
B
belts. Do not open
C
sheaves more than nine 1/2
turns.
4
Tighten both locking screws
A
in the outer locking ring.
5
Put on the belts and adjust the belt tension. Do not force
belts over grooves. Loosen the belts by adjusting the motor
base closer to the fan shaft.
Figure 111. LVP variable pitch sleeves
Figure 112. MVP variable pitch sheaves (type A-B)
CAUTION
Do not loosen any screws other than the two locking screws (A)
in the outer locking ring. Before operating the drive, securely
tighten these screws.
S e c t i o n A - A S e c t i o n A - A
A
B
C
D
E
F
D
E
A
E
C
F
D
A
A
C e n t e r F l a n g e s
G a p
O u t e r L o c k i n g
R i n g
L o c k i n g
S c r e w s
" A "
3 C a p s c r e w s " B "
I n n e r L o c k i n g
R i n g
S p a n n e r W r e n c h
H o l e
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com