McLaughlin VERSA-MOLE McL-10H, Компоненты и руководство по ремонту

Страница: 42 / 47

pulley pins are for the two (2) small and two (2)
larger slider pulleys.
30. Install the spiral locking rings. Be sure they are
properly seated in the pulley pin groove.
STEP 10: SLIDER PULLEY INSTALLATION
31. Screw the slider pulley onto the end of the cylinder
rod. Using a chain clamp to hold the rod, tighten
the slider pulley assembly.
STEP 11: HYDRAULIC CYLINDER INSTALLATION
32. Place the hydraulic cylinder in the frame. NOTE:
The steel tabs on the slider pulley assembly must
be facing down. Rotate the cylinder rod as re-
quired.
33. Install the cylinder pin and R-clip.
STEP 12: THRUST CHAIN INSTALLATION
34. Connect the chains to the rear plate of the frame by
using connecting links. Connecting links consist of:
(1) master link, (2) individual links, and (2) cotter
pins.
35. Thread the chain through the slider pulleys and up
over the upper frame pulleys.
36. Connect the chains to the threaded chain clevises
by using connecting links.
37. Slide the front chain clevis through the stop block
on the slider angle and install the turnbuckle. Only
engage the chain connector for 2-3 revolutions.
38. On the rear chain, the chain connector must have
the fl oat indicator placed on it after being inserted
into the stop block on the slider angle.
39. Put the bottom chian tensioner through the tube.
Install the spherical washers and tighten the nut so
it is fully threaded on the chain tensioner.
40. Pull the second chain connector to the turnbuckle
and rotate the turnbuckle to engage the threads.
Be careful not to thread the turnbuckle too far onto
the opposite chain clevis.
41. Apply a few drops of Loctite #243 removable
thread locker to the threaded clevises of the turn-
buckle.
42. With both chain clevises threaded in the turnbuck-
le, begin tightening with a screwdriver. Rotate the
turnbuckle until the chain is tight when hit with a
wrench.
43. Push the fl oat indicator or collar fl ush with the rear
of the turnbuckle and tighten.
44. Remove any remaining slack in the chain by tight-
ening the nut on the bottom chain tensioner.
45. Straighten out the chains after tightening.
46. Lubricate the chain with all-purpose of grease.
STEP 13: CONVEYOR BELT INSTALLATION
47. Set the backing nut on the side sheet studs. The
dimension from the edge of the angle to the front
edge of the nut should be 2”.
48. Place a 1/2” fl at washer on all studs except the (2)
end studs near the pulleys.
48. Slide the conveyor up to the backing nuts on all
9.6.0
37
40
42
43
47