McLaughlin VERSA-MOLE McL-10H, Компоненты и руководство по ремонту

Страница: 3 / 47

GENERAL MAINTENANCE
McL-10H VERSA-MOLE
CARRIAGE
Check all screws and nuts initially and then every week when
in continuous use. Tighten all loose nuts and screws. Replace
missing nuts or washer.
HYDRAULICS
Check all hoses and fi ttings for leaks initially and then every
week when in continuous use. When tightening fi ttings, be care-
ful not to twist hoses from their original positions.
Relieve system pressure before disconnecting hoses.
Clean the quick-disconnects and install the dust caps.
LUBRICATION
Lubricate the cam rollers with 1-2 pumps of grease each week.
Lubricate the chain drive every 2-3 days when in continuous use.
Use the grease fi tting on the sprocket guard and use 4-5 pumps
of all-purpose grease. Rotate the spindle while greasing the
chain.
Lubricate the bearing carrier every 4-5 days when in continuous
use. Use the grease fi tting on the top of the bearing housing.
Use about 4-5 pumps of all-purpose bearing grease. (Photo 1)
Disassemble, inspect and re-pack spindle bearings every 1000
hrs or every 12 months.
CHUCK
Check threaded chuck, each day in use. Check for scarred
threads. NOTE: Always use an approved drill thread lubricant
on the chuck and drill rods to prevent damage to the threads.
Use
Jet-Lube - KOPR-KOTE with CZ-EX or equivilent. (Photo 2).
Check hex chuck evey day in use.
Lubricate hex on augers and chuck with penetrating oil.
NOTE: If the carriage is submerged under water:
Drain sprocket guard by removing bottom plug.
Re-lubricate bearing carrier, 4-5 pumps of grease.
Re-lubricate chain, 4-5 pumps of grease.
FRAME
SHEET METAL GUARDS
Check sheet metal guards each day. Make sure that guards are
properly secured at the top and the bottom. DO NOT OPERATE
MACHINE WITHOUT GUARDS IN PLACE. Replace missing or
damaged guards immediately. (Photo 3).
CONVEYOR GUARDS
Check condition of belting material each day. Replace as neces-
sary.
THRUST CHAIN
Check tension on thrust chain each week. Tighten as required
using the bottom adjusting nut. The chain should be tight when
tapped with a wrench. (Photo 4).
LUBRICATION
Grease the thrust chain once a week. Apply a light fi lm of
grease to the top and bottom of the chain. The thrust chain must
be re-lubricated after each time it is cleaned with a pressure
washer.
1.2.0
1
2
3
4
5
1
3