McLaughlin VERSA-MOLE McL-10H, Компоненты и руководство по ремонту

Страница: 41 / 47

or loose. Rotate the turnbuckle until the threaded
chain connectors completely unscrew.
10. Slide the chain connectors out of the slider angles.
The fl oat indicator or collar must be removed from
the chain connector before it will slide thrught the
stop block.
11. Remove the nut on the bottom chain tensioner and
slide the chain clevis out of the bottom tube.
12. Remove the connecting link between the thrust
chain and the chain connectors. Be careful not to
loose the individual chain links during disassembly.
Discard the original cotter pins.
13. Remove the connecting links between the thrust
chain and the frame rear plate. Be careful not to
loose the individual chain links during disassembly.
Discard the original cotter pins.
14. Thread the chains through the top pulleys at each
end of the frame.
15. Lift the end of the hydraulic cylinder and thread the
chains through the two (2) cylinder pulleys.
16. Remove the chains from the machine.
STEP 4: THRUST CYLINDER REMOVAL
17. Disconnect and cap the hydraulic hoses and fi ttings
on the thrust cylinder.
18. Remove the R-clip pin on the inside of the ma-
chine.
19. Remove the cylinder pin.
20. Remove the cylinder.
STEP 5: SLIDER PULLEY REMOVAL
21. Place the thrust cylinder on a stable surface.
22. Use a chain clamp to grasp the cylinder rod. Be
careful not to damage or scar the rod.
23. Unscrew the slider pulley off the end of the cylin-
der rod. Be sure exposed threads on the cylinder
rod are clean to prevent the threads from getting
jammed.
STEP 6: PULLEY REMOVAL AND DISASSEMBLY
24. Remove the spiral locking ring on one end of the
pulley pin.
25. Remove the pin and the pulley. Chick the plastic
bushings for wear or damage. Replace if neces-
sary.
STEP 7: BUSHING REMOVAL
26. Break off the shoulder of the bushing and push it
out of the pulley.
DISASSEMBLY
STEP 8: BUSHING INSTALLATION
27. Press the new bushing into the pulley. Be sure the
shoulder of the bushing is tight against the pulley
side. Check the fi t with a pulley pin.
STEP 9: PULLEY INSTALLATION
28. Lubricate the inside of the pulley bushing with all
purpose grease.
29. Slide the pulley into place and install the pulley pin.
NOTE: The four (4) long pins are for the four (4)
small diameter frame pulleys. The four (4) short
9.5.0
10
12
22
25
29