10
Installation
Installation
The MVP891 can be placed upright on a table or
shelf, standing on its four feet. It also can be custom
installed in a piece of furniture or cabinet of your
choice. The four feet may be removed from the bottom
of the MVP891 when it is custom installed as out
-
lined below. The four feet together with the mounting
screws should be retained for possible future use if the
MVP891 is removed from the custom installation and
used free standing. The required panel cutout, ventila-
tion cutout and unit dimensions are shown.
Always provide adequate ventilation for your
MVP891. Cool operation ensures the longest possible
operating life for any electronic instrument. Do not
install the MVP891 directly above a heat generat
-
ing component such as a high powered amplifier. If
all the components are installed in a single cabinet, a
quiet running ventilation fan can be a definite asset in
maintaining all the system components at the coolest
possible operating temperature.
A custom cabinet installation should provide the fol-
lowing minimum spacing dimensions for cool opera-
tion.
Allow at least 6 inches (15.24cm) above the top, 2
inches (5.08cm) below the bottom, 3 inches (7.62cm)
behind the rear panel and 2 inch (5.08cm) on each
side of the Audio Video Player, so that airflow is not
obstructed.
Do not block the ventilation holes on the
top and bottom cover;
also do not block the rear
panel fan opening.
Allow 1 inch (2.54 cm) in front
of the mounting panel for clearance. When the DISC
Tray is opened, the panel clearance required in front
of mounting panel is 6-3/4 inches (17.2cm).
Be sure to
cut out a ventilation hole in the mounting shelf ac-
cording to the dimensions in the drawing.
MVP891 Front Panel
Custom Cabinet Cutout
8"
20.3cm
14"
35.56cm
13-
1/4
"
33.7cm
3/4
"
1.9cm
Cutout Opening
for Ventilation
Cutout Opening for Ventilation
Support
Shelf
Cabinet
Front
Panel
Chassis
Spacers
MVP891 Side View
in Custom Cabinet
MVP891 Bottom View
in Custom Cabinet
2-
5/8
"
6.7cm
7"
17.8cm
3-
1/8
"
7.9cm
Note: Center the cutout Horizontally on the unit.
For purposes of clarity, the above
illustration is not drawn to scale.
Opening
for Ventilation
6"
15.24cm
10-
7/8
"
27.62cm
17-
1/16
"
43.34cm
Cutout Opening for Custom Mounting
Cabinet Front Panel
Opening for Ventilation
Opening for Ventilation
