23
of operational steps for adjusting the TREBLE, BASS
and MODE Selection:
1. Select “AMP METERLIGHT, On” as indicated
on the Front Panel Information Display. Refer to
figure 80.
2. Switch Off the Meter Illumination by using the
Front Panel Controls or Remote Control Push-
buttons. Refer to figure 81.
After approximately 6 seconds the Information
Display returns to indicate the Source Selection and
Volume Level.
INFORMATION DISPLAY ILLUMINATION
The Brightness Level of C49 Front Panel Information
Display can be adjusted from bright to dim by per-
forming the same type of operational steps for adjust-
ing the TREBLE, BASS, MODE, etc:
1. Select “DISPLAY, BRIGHTNESS” as indicated
on the Front Panel Information Display. Refer to
figure 82.
2. Reduce the Brightness level by adjusting the
TRIM LEVEL. Refer to figure 83.
Figure 80
AMP METERLIGHT
On
Figure 81
AMP METERLIGHT
Off
After approximately 6 seconds the Information
Display returns to indicate the Source Selection and
Volume Level.
PHONO ADJUSTMENTS
First select the Phono MC or Phono MM Input for the
type of Phono Cartridge installed on the Turntable
currently be used. Then press and then rotate the
INPUT Control to display the active type of load set-
ting for the Phono Cartridge Selected. Refer to figures
84 (Moving Coil Cartridge) or 85 (Moving Magnet
Cartridge).
Then rotate the VOLUME Control to to adjust the
Phono Cartridge load value. After approximately 6
seconds the Alphanumeric Display returns to indicate
the Source Selection and Volume Level.
Mute
Press the MUTE Push-button, on the C49 Front Panel
or on the Remote Control, to Mute the Audio in all
outputs (Main, Output 1, Output 2 and Headphones)
except the FIXED OUTPUT. The Front Panel Infor-
mation Display will indicate the Source Name and
the word MUTE in place of the actual volume setting.
Refer to figure 86.
Pressing the Mute Push-button a second time or
adjusting the volume control (either the Front Panel or
Remote Control) will unmute the C49.
Tone
Press the Front Panel TONE Push-button to activate
the C49 TREBLE and BASS Tone Control Circuitry
for the currently selected Input Source. Refer to Page
21 and 22 for operation. The LED above the TONE
Push-button will illuminate. To bypass the TONE
CONTROL CIRCUITRY for the currently selected
Input Source press the TONE Push-button. The LED
above the TONE Push-button will extinguish.
Refer to figure 60. The C49 remembers for each
selected Input whether the Tone Control Circuitry is
active or bypassed.
Note. The audio signal present at the FIXED OUT
Jacks is unaffected by the Equalizer Circuitry.
Output 1 and 2
Press the Front Panel OUTPUT 1 or OUTPUT 2
Push-button or use the Remote Control and press the
SETUP/BLUE Push-button followed by the OUTPUT
1 or OUTPUT 2 Push-button, to send audio to sepa-
rate Power Amplifiers connected to the rear panel
OUTPUT 1 or 2 Jacks. It also activates the POWER
CONTROL TRIGger 1 or 2 Jacks on the rear panel of
the C49. To stop the Audio and Power Control Signals
from going to the separate Power Amplifiers, press the
same Push-button(s) a second time.
How to Operate the C49, con’t
Figure 83
DISPLAY
BRIGHTNESS
Figure 82
DISPLAY
BRIGHTNESS
Figure 84
PHONO RESISTANCE
100
O
Figure 85
PHONO CAPACITANCE
50 pF
Figure 86
BAL 1 MUTE
