19
Output Meters
The C2300’s Output Meters indicate the Output
Voltage available at the MAIN and OUTPUT 1 & 2
Jacks to drive Power Amplifiers. Refer to figure 27.
The Meters are calibrated in dB (decibels) and respond
to all the peaks contained in the musical informa-
tion. They indicate to an accuracy of at least 95% of a
single cycle from a 2000Hz tone burst.
The Meter Electronic Circuitry “Time Stretches” the
Meter Drive Signal so the Meter Pointer pauses just
long enough for the human eye to see it and is fol-
lowed by a moderate decay rate.
How To Make A Recording
1. Select the Source Input Signal you wish to record.
2. Adjust the record level using the recorder volume
control and proceed with the recording process.
3. To listen to the playback of the program source
just recorded, press the RECord MONITOR Push-
button.
Note: The C2300 SRVR (REC) OUTPUTS are not af-
fected by the VOLUME or BALANCE controls.
Reset of Microprocessors
In the unlikely event the controls of the C2300 stop
functioning, the microprocessors can be reset by per-
forming the following:
Pressing the Mute Push-button a second time or
adjusting the volume control (either the Front Panel or
Remote Control) will un-mute the C2300.
If the Front Panel MUTE Push-button is pressed
for at least 3 seconds, the C2300 will mute the OUT-
PUTS connectors, yet listening with headphones will
continue until the Mute Push-button is pressed again
for 3 seconds. The Front Panel Alphanumeric Display
will indicate the Input Source Name, Volume Setting
and a Dot. Refer to figures 25 and 26.
Output 1 and 2
Press the Front Panel OUTPUT 1 / OUTPUT 2 Push-
button or use the Remote Control and press the 2nd
Push-button followed by the OUTPUT 1 / OUTPUT
2 Push-button to send audio to separate Power Am-
plifiers connected to the rear panel OUTPUTS 1 or
2 Jacks. It also activates the POWER CONTROL
OUTPUT 1 /OUTPUT 2 Jacks on the rear panel of the
C2300. To stop the Audio and Power Control Signals
from going to the separate Power Amplifiers, press the
same Push-button(s) a second time.
Headphones Jack
Connect a pair of dynamic headphones with a 1/4”
(0.635cm) stereo phone type plug to the Headphones
Jack for private listening.
How to Operate the C2300, con’t
Figure 26
Figure 27
Figure 25
1. Press and hold in the STANDBY/ON Push-button
for approximately five seconds and then release the
push-button.
2. Press the STANDBY/ON Push-button, the C2300
will resume normal operation.
Note: This can be performed with the C2300 On or in
the Standby Mode.
