13
The C2300 can be part of a Multichannel Sound Sys-
tem for SACD, DVD-Audio and Home Theater. The
Right and Left Front Channels from a McIntosh A/V
Control Center or Surround Decoder can “Passthru”
the C2300 and onto its associated Power Amplifier(s).
The Setup Mode allows the activation of the Passthru
Mode and the Selection of the C2300 Input (Input
numbers 3 - 8 on the Rear Panel) that will be used for
the Right and Left Front Channels. In the example
below, the Right and Left Front Channels from the
Multichannel Processor/Decoder will be connected to
the CDR (7) Input Jacks on the C2300. Refer to page 9
for additional connection information.
1. Press the SETUP Push-button to access the Setup
Mode.
2. Rotate the MENU Control until “PASSTHRU
OFF” appears on the Front Panel Alphanumeric
Display.
2. Rotate the MENU Control until “TRIG TUNER
> - - ” appears on the Front Panel Alphanumeric
Display. Refer to figure 8.
3. Rotate the SELECT 1 Control until the display
indicates “TRIG DVD > - - ”.
4. Rotate the SELECT 2 Control until the display
indicates “TRIG DVD > A ”. Refer to figure 9.
5. Press the SETUP Push-button to exit the Setup
Mode.
Setup, con’t
Figure 9
Figure 8
Accessory Power Control
The ACC (C) Power Control Output is reassignable
from the default setting of going ON/OFF with the
C2300 (Main), to being controlled by the Remote
Control ACC ON/OFF Push-buttons. To reassign it
perform the following:
1. Press the SETUP Push-button to access the Setup
Mode.
2. Rotate the MENU Control until “ACC < C >
MAIN” appears on the Front Panel Alphanumeric
Display.
3. Rotate the SELECT 2 Control until the display
indicates “ACC< C > ON”. Refer to figure 10.
4. Press the SETUP Push-button to exit the Setup
Mode.
Tube LED
To swich Off the Tube LED green illumination per-
form the following:
1. Press the SETUP Push-button to access the Setup
Mode.
2. Rotate the MENU Control until “TUBE LED ON”
appears on the Front Panel Alphanumeric Display.
3. Rotate the SELECT 2 Control until the display
indicates “TUBE LED OFF”.
4. Press the SETUP Push-button to exit the Setup
Mode.
Figure 10
Passthru
Figure 11
3. Rotate the SELECT 2 Control until the display
indicates “PASSTHRU 7 ”. Refer to figure 11.
4. Press the SETUP Push-button to exit the Setup
Mode.
