17
2. Rotate the TRIM ADJUST Control or press the
LEVEL + / - Push-buttons to increase or decrease
the volume level of the low frequencies. Refer to
figure 17.
The Front Panel Display indicates the Bass changes in
steps from -12dB to (+)12dB. After approximately 3
seconds the Alphanumeric Display returns to indicate
the Source Selection and Volume Level.
TREBLE
The Intensity of the High Frequencies in the music can
be increased or decreased by using the Trim Select
and Trim Adjust Controls. To make adjustment per-
form the following:
1. Rotate the Front Panel TRIM SELECT Control
or press the TRIM Push-button on the Remote
Control until “TREBLE __” appears on the Front
Panel Alphanumeric Display.
2. Rotate the TRIM ADJUST Control or press the
LEVEL + / - Push-buttons to increase or decrease
the volume level of the high frequencies. Refer to
figure 18.
The Front Panel Display indicates the Treble changes
in steps from -12dB to (+)12dB. After approximately
3 seconds the Alphanumeric Display returns to the
indicate the Source Selection and Volume Level.
TONE ENABLE/BYPASS
With the Tone Bypass active, the Bass and Treble
Settings for the currently selected Input Source are
electronicaly bypassed. When the Tone Bypass is
switched Off the previous settings for Bass and Treble
will be restored. To activate Tone Bypass perform the
following:
1. Rotate the Front Panel TRIM SELECT Control or
press the TRIM Push-button on the Remote Con-
trol until “TONE BYPASS” appears on the Front
Panel Alphanumeric Display.
2. Rotate the TRIM ADJUST Control or press the
LEVEL + / - Push-buttons to activate the Tone
Bypass or deactivate the Tone Bypass. Refer to
figure 19.
After approximately 3 seconds the Alphanumeric
Display returns to indicate the Source Selection and
Volume Level.
TRIM LEVEL
The Trim Level adjustments allows for making fine
adjustments to the previously performed Trim Level
Adjustments in the Setup Section of this Owner’s
Manual on page 11. To make fine adjustment to the
currently selected Input Source perform the following:
1. Rotate the TRIM SELECT Control or press the
TRIM Push-button on the Remote Control until
“LEVEL _._” appears on the Front Panel Alpha-
numeric Display. Refer to figure 20.
2. Rotate the TRIM ADJUST Control or press the
LEVEL + / - Push-buttons to adjust the volume
level from -6dB to (+)6dB.
Refer to figure 20.
After approximately 3 seconds
the Alphanumeric Display re-
turns to the indicate the Source
Selection and Volume Level.
METER ILLUMINATION
The C2300 Front Panel Meter
Illumination may be switched
On or Off by performing the
following:
1. Rotate the TRIM SELECT
Control or press the TRIM
Push-button on the Remote
Control until “METER
ON” appears on the Front
Panel Alphanumeric Dis-
play.
2. Rotate the TRIM ADJUST
Control or press the LEVEL
+ / - Push-buttons to switch
On or Off the Meter Illumi-
nation.
After approximately 3 seconds
the Alphanumeric Display re-
turns to the indicate the Source
Selection and Volume Level.
Note: When the Main Power
Control of the C2300 is
connected to a McIntosh
Power Amplifier with Re-
mote Meter Illumination Control, the C2300 Meter
Illumination Setting of On or Off will also affect
the Power Amplifer Meter Illumination.
How to Operate the C2300
Figure 17
Figure 18
Figure 19
Figure 21
Figure 20
