18
Mono
Press the Front Panel MONO Push-button or the
MODE Push-button on the Remote Control to com-
bine left and right stereo signals to a Monophonic Sig-
nal. The Front Panel LED will illuminate indicating
the MONO Mode is active. The C2300 automatically
stores into memory for each Input, the Selection of the
Stereo or Mono Mode.
Note: The signals at the SRVR OUT (REC) Jacks are
not affected.
Record Monitor
Press the REC MONITOR Push-button to hear the
SERVER Playback Signal during the recording pro-
cess.
Setup
Pressing the SETUP Push-button activates the Setup
Mode of the C2300 and allows customizing various
operating functions. Refer to page 11 for additional
information.
Mute
Press the MUTE Push-button, on the C2300 Front
Panel or on the Remote Control, to Mute the Audio at
the OUTPUTS Connectors and HEADPHONES Out-
put Jack. The Front Panel Alphanumeric Display will
indicate the Input Source Name followed by the word
MUTE in place of the actual volume setting. Refer to
figure 24.
PHONO ADJUSTMENTS
When the Phono MC or Phono MM Input is selected
an additional TRIM SELECT FUNCTION becomes
available for adjustment. Perform the following steps
to make the Phono Trim Adjustments:
1. Select either the Phono MM or Phono MC Input
using the INPUT Control.
2. Rotate the TRIM SELECT Control or press the
TRIM Push-button on the Remote Control until
“PHMM _ _ _ PF” or “PHMC _ _ _ OHM”
appears on the Front Panel Alphanumeric Display.
Refer to figures 22 and 23.
3. Rotate the TRIM ADJUST Control or press the
LEVEL + / - Push-buttons to select from the
available values of cartridge loading (Ohms for a
Moving Coil Cartridge or Capacitance for a Mov-
ing Magnet Cartridge) that comes closest to the
Cartridge Makers recommended value.
After approximately 3 seconds the Alphanumeric
Display returns to the indicate the Source Selection
and Volume Level.
Tone Bypass
Press the TONE BYPASS Push-button to Bypass the
Tone Control Circuitry, thus providing a flat frequen-
cy response. If the AUTOTONE circuit is set to the
On position in Setup Mode, the C2300 will remember
for each input whether the Tone Bypass is active. The
Front Panel LED will illuminate indicating the BY-
PASS Mode is active.
How to Operate the C2300, con’t
Figure 24
Figure 22
Figure 23
Figure 14
