McElroy 2CU, Руководство оператора

Страница: 13 / 34

Overview
Heater
Heater is not explosion proof. Operation of heater in an
explosive atmosphere without necessary safety precautions
will result in serious injury or death.
If operating in an explosive atmosphere, heater should be brought up to
temperature in a safe environment, then unplugged before entering the
explosive atmosphere for fusion.
The heater has a green indicator light which will flash on and off. This
indicates that the controller is operating normally. If the green indicator is
not flashing then the controller may not be operating properly. If this occurs,
disconnect power and have the heater repaired by a McElroy Authorized
Service Center.
The heater temperature is controlled by a microprocessor. It has a red
indicator light on the handle at the bottom of the temperature scale. When
the heater is plugged in and preheating the light glows steadily until the set
temperature is reached. The light then goes off and on slowly as the heater
maintains temperature.
The heater body is not coated. Coated fusion heater adapters are available
for all fusion applications.
NOTICE:
The heater should never be used without fusion heater adapters
installed.
To prevent a build-up of plastic pipe residue from accumulating on the heater
plates (loss of surface temperature and pipe sticking may result), the heater
plates should be cleaned with a non-synthetic cloth before every fusion joint.
TX02216-04-16-14
PH02
17
4-6-2
2-0
1
Manual Facer
The manually operated facer has a hand powered crank. Turn the crank
counterclockwise for facing.
TX00836-1-5-96
Insulated Heater Stand
The heater should always be stored in the insulated heater stand or
blanket for protection of the operator and to minimize heat loss and risk of
mechanical damage.
TX00363-9-15-94
PH0
1008-1
2-1
0-9
6
PH02
408-1
2-3-02
PH02
409-1
2-3-02
2 - 3
¡PELIGRO! ¡PELIGRO!