36
Operation
Preparation
Effect Light Addresses
The DMX light control device assigns starting addresses in steps of 20 to the 12 encodable effect lights. Therefore
also code your effect lights in steps of 20, because channels cannot be assigned correctly otherwise.
Effect Light Start Address
Effect Light Start Address
Effect Light Start Address
1
1
5
81
9
161
2
21
6
101
10
181
3
41
7
121
11
201
4
61
8
141
12
221
All effect lights with the same starting address will work synchronously.
Channel Assignment
The DMX light control device can control up to 12 effect lights with up to 20 channels each.
• The first 8 channels (1-8) are controlled directly through the channel faders (18). For this, the LED A above the
PAGE SELECT A/B (19) button must be lit.
• The second 8 channels (9-16) are also controlled through the channel faders (18), but the
PAGE SELECT A/B (19) button must be pressed first, so that the LED B above the PAGE SELECT A/B (19)
button lights up.
• When the PAGE SELECT A/B button (19) is pressed again, both LEDs A and B will light up. Now all channels
can be controlled at once through the channel faders (18).
If your effect light is to have more than 16 channels, you may assign the remaining channels as follows:
• Press the FINE (15) and MODE (14) buttons at once twice until the ASSIGN LED below the display (6) lights up.
• Select the desired light effect with the respective SCANNER (1) button. The corresponding LED must flash.
• First use the FADE TIME (16) fader to select the desired light control device channel. The channel is indicated
on the display (6).
• Then use the SPEED fader (17) to select the light control device channel to be assigned. The channel is indicated
on the display (6).
• Briefly press the FINE (15) and MODE (14) buttons to save the setting.
