WARNING BEFORE USE
In order to put your stove in regular operation, it is very important to read these
instructions and observe instructions for use and handling.
For combustion, use solid fuel like wood, briquette, but not stone coal due to its high
calorie combustion power.
It is forbidden to put explosive devices and materials into the firebox or onto the
stove hotplate.
It is forbidden to keep inflammable materials within the close vicinity of the stove.
For proper combustion, within the normal operational mode, draught in the chimney
should be 15-17 Pa. In case if draught is higher then 20Pa, it is necessary to install
chimney flap.
Room in which stove is located should be regularly ventilated due to flow of fresh air
necessary for combustion.
Parts of stove are heated within period of operation and appropriate handling
precaution is necessary. Do not allow children to handle and play in the vicinity of the
stove.
Do not allow handling with the stove to the persons with limited physical and
psychical abilities.
Do not allow pets to be close to the device.
Only spare parts approved by the manufacturer may be installed onto the furnace.
One may not make any changes to the furnace.
Upon the first heating, smoke and various scents may occur, especially on the
surfaces protected with the color and other anti-corrosive primers. Ventilate the
room.
Thermal regulator is integral part of the stove and set-up at the factory. Do not make
any adjustments of thermal regulator by yourself.
When adding fuel, open fire door for only few degrees, wait 4-5 seconds until
pressure in the firebox and room comes equal, then open it wide very slowly. Do not
open the door abruptly, so when flame is strong in the firebox it may come out of the
firebox. Do not open firebox door unnecessarily, always paying attention to open it
when flame is weak.
In case of non-observance of these instructions for use, manufacturer will not
be liable for any damage on stove.
