14
www.MBOservice.net
USING THE PULSE COMPUTER
1. Setting the alarm zone
In pulse mode, keep pressing key “
B
” until the
letters ZN are displayed in the centre line of the
display. Press and hold down key “
C
” until the
symbols for the upper and lower training limits
start to flash.
Use key “
B
” to select one of the following
zones:
Alarm only when you exceed the training
zone – 2 beeps per second
Alarm only when you fall below the
training zone – 1 beep per second
Alarm when the pulse is outside the
training zone
After setting the alarm zone, press key “
C
” to
switch to training zone selection mode.
2. Selecting the training zone
After switching to training zone selection mode,
the currently selected training zone (1, 2, 3 or U)
in square brackets starts to flash. The relevant
upper and lower limits also flash in the bottom
line. You can switch between the 4 training
zones by pressing key “
B
”. Confirm your selec-
tion with key “
C
”. This completes the alarm zone
selection process.
Note:
You must set the alarm zone before selecting the
training zone.
Z
O
N
E
Z
O
N
E
B
C
B
C
Merkura 1050 GB neu 27.03.2003 8:31 Uhr Seite 14
