46
4. Adjusting the Program
Descriptions of Keys on the Control Panel
4-1 Maintenance Mode
Switching to the Maintenance Mode
(1) Power the product off.
(2) Just after powering it on, press the [+], [-], [AUTO], and [MANUAL] keys at the same time.
(3) Together with the beep, the version number will be displayed for about three seconds.
(4) Press the [+] and/or [-] keys to select the desired function and press [START] to confirm the
selection.
Function 1: Adjusting sensitivity of the touchpad
Function 2: Switching between
metric
and
inch
measurements
Function 3: Adjusting the folding position
Function 4: Adjusting the origin of the paper feed sensor
Function 5: Adjusting the staple position
Function 6: Freely operating individual motors
Function 7: Displaying total shot counts
If the function is left unconfirmed for 20 seconds after start-up, Function 1 will be automatically
confirmed.
Function 1: Adjusting sensitivity of the touchpad
This function automatically adjusts the sensitivity of the touchpad on the control panel. Carry out
this adjustment when the touchpad sensitivity is abnormal or when the control panel has been
replaced.
Values ranging from 1 to 14 are displayed. As the values change, there is a brief beep. When
the value turns 14 with a long beep, the function process is finished and the product will
automatically restart.
The sensitivity adjustment is conducted automatically. In the course of the adjustment, do not
touch the control panel.
Function 2: Switching between
metric
and
inch
measurements
This function switches between metric and inch measurements. Press the [+] and/or [-] keys to
select the desired value and press [START] to confirm the selection and the product will
automatically restart.
1: Metric measurements
2: Inch measurements
Function 3: Adjusting the folding position
This function is for the fine adjustment of the position at which paper is folded.Carry out this
adjustment when the staple position or the folding position deviates from the center of the paper.
Never operate this function before carrying out the adjustment using Function 5,
Press the [+] and/or [-] keys to set the value in the range from 0 to 99. A value change by 1
means a change in position by 0.1 mm.
An increase in the value means that the staple position and the folding position move in an
identical direction with the paper insertion direction.
A decrease in the value means that the staple position and the folding position move in the
CORNER
FONLY
F&S
DOWN
UP
FLA
T
LOO
P
AUTO MANUAL
