31
3-19 Replacing Sensors
1. Following the steps in
3-1 Replacing the Outer Covers
, remove the front cover, the rear cover,
and the side cover R.
2. Remove sensors.
Replacing the Push-Up (Upper) Sensor and Stapler (Lower) Sensor
(1) Unfasten two screws to remove the plate.
(2) Remove the push-up sensor (above) and the stapler sensor (below).
Replacing the Clincher Sensor
(1) Remove the clincher sensor.
If the plate interferes, unfasten the screws to remove it as well.
Push-Up (Upper) Sensor
(102 [Sensor])
Connect Cable J8
Stapler (Lower) Sensor
(below)
(102 [Sensor])
Connect Cable J7
245 [Plate]
At the time of reassembly, fasten it in
its original position.
2-NC3x6
Clincher Sensor
(102 [Sensor])
Connect Cable J12
2-NC3x6
At the time of reassembly,
fasten it in its original position
285 [Plate]
板
]
