26
1. Masking not required.
2. Coat the sensor surface with the body color paint.
3. Use two-component urethane paint. (Main
component: acrylicpolyol, curing agent: isocyanate)
Maximum paint thickness: primer 30 um, paint and
coating 95 um in total.
4. When painting, use a spray gun to apply the paint
evenly.
Paint infiltration into connector must be avoided;
pin contact must be guaranteed after painting.
Maximum paint curing: 90 C for 1 hour.
5. After baking, do not touch the painted product until
it has cooled down completely.
Hot storage temperature: 85 C.
6. When the painting is dried, remove the sensors and
the bezels from plastic base.
6. PAINT SENSOR
Paint characteristics vary according to paint
type. Check manufacturer specifications
before painting.
CAUTION
Do not use lacquer paints because their
weatherproofing and adhesion characteristics
are poor.
CAUTION
Be careful not to peel off the paint when
removing the sensors and the bezels from
plastic base.
CAUTION
SURFACE TREA TMENTT
a: Paint same as body color
b: Masking not required
