Component Testing Information
!
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect power to washer before servicing, unless
testing requires it.
16022616 Rev. 0
October 2003
4
Illustration
Component
Test Procedure
Results
2 Speed Motor
CCW rotation from
viewed from shaft
end.
1/2HP
120V/60hz, 8.7 amps
@ 1725 RPM/7.4
amps @ 1140 RPM
Main wattage,
700/570 watts
See section “Internal Motor Diagram and Schematic for wiring
contacts.
Water valve
120V 50/60hz, 5
watts Cold Side 2.25
gpm, Hot Side 2.00
gpm, Mix 3.00 gpm at
30-120 psi
Measure resistance of terminals on each valve.
Resistance across each valve.
1000
Ω
± 10%
Drain Pump
Verify Drain Pump is not clogged or damaged.
Lid Switch
Disconnect wire terminals from switch. Test terminals with
switch closed. Test terminals with switch open.
Continuity >1
Ω
Infinite 1M
Ω
Timer
Verify input and output voltage is present
.
Refer to timing
sequence chart.
Pressure Switch
Do not disconnect the pressure hose from pressure switch to
perform measurements. Measure resistance across the
following terminals.
Terminal 1 to 2
Terminal 1 to 3
Refer to wiring
diagram/schemat
ic for correct
contacts.
Continuity >1
Ω
Infinite 1M
Ω
