Trouble Shooting
!
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect power to washer before servicing, unless
testing requires it.
October 2003
16022616 Rev. 0
3
Wrong Water Temperature
•
Are both faucets on fully?
•
Make sure temperature selection is correct.
•
Make sure hoses are connected to correct faucets
and inlet connections. Flush water line before filling
washer.
•
Check the water heater. It should be set to deliver a
minimum 120°F (49°C) hot water at the tap. Also
check water heater capacity and recovery rate.
•
If the water heater is located a long distance from
washer, water line may need to be purged prior to
starting wash cycle.
•
Disconnect inlet hoses and clean screens.
Will Not Spin
•
Check for unbalanced load.
•
Does the house drain system accept water from
machine?
•
Check for blocked drain hose.
•
Check for binding tub seal.
•
Check for partial engagement of brake assembly.
•
Check for obstruction between tubs.
•
Check for broken impeller on pump.
Clothes Wet After Spin
•
Check for unbalanced load.
•
Check for slipping belt.
•
Check for partial engagement of brake assembly.
•
Check pump for obstruction.
•
Check for drain hose restriction.
•
Check for drain plumbing restriction.
Tub Full of Water
•
Check for drain hose restriction.
•
Check for drain plumbing restriction.
•
Check pump for obstruction or proper operation.
•
Check for proper polarity of motor against timer
sequence chart.
•
Check for loose or slipping belt.
