Trouble Shooting
!
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect power to washer before servicing, unless
testing requires it.
16022616 Rev. 0
October 2003
2
Model/Switch Type Tub Size Low Med
High
Home-Variable
3.3
6.75+1 NA 14.25+.5/-1
Leaking
•
Make sure supply hose connections are not leaking.
Check for rubber gasket damage due to over
tightening.
•
Make sure end of drain hose is correctly inserted
and secured to drain facility.
•
Avoid overloading.
•
Check internal hose connections.
•
Check for overflowing standpipe.
•
Check pump out speed.
•
Check tub cover. Remove, reposition and reinstall
the tub cover seal.
•
Check water mixing valve for cracks or hose
connection leak.
•
Check tub seal for leak.
•
Check for water inlet flume damage.
No Water Fill
•
Check to make sure water supply turned on fully.
•
Normal water level. See chart.
•
Check for kinks in inlet hoses.
•
Check for clogged inlet screens.
•
Visually check hot and cold separately at dispenser
for proper flows.
•
If complaint is a high-pitched noise during fill then
disconnect supply hoses and clean screens.
•
Is 120VAC present at outlet.
•
Check for blown fuse or tripped breaker.
•
Check lid switch assembly.
•
Check Pressure Switch for continuity between
terminals. (See component testing)
•
Check timer contacts.
•
Check for continuity on water valve solenoid. (See
component testing)
Vibration
•
Weak floors can cause vibration and walking.
•
Legs level and secure.
•
Be sure rubber feet are installed on leveling legs.
•
Check that the leveling leg lock nuts are tightened.
•
Remove front panel and check that the suspension
springs are attached to the base and outer tub.
•
Check agitator for correct installation.
•
Check transmission for spin bearing noise.
•
Check belt.
•
Check pump pulley and bearing.
•
Check motor pulley and bearings.
Will Not Start
•
Plug cord into live electrical outlet.
•
Check fuse or reset circuit breaker.
•
Close lid.
•
Check to see if the washer in a pause or soak
period in the cycle. Wait briefly and it may start.
•
Check for restricted drain system.
•
Check cam chart per cycle.
Will Not Drain
•
Check for restricted drain system.
•
Check for broken impeller on pump.
Models
SAV205DAW/2655AW
Models
SAV205DAW/2655AW
Power Source
Wash cycles
11
Voltage AC
120 VAC
Water temperatures
4
Amperage (Single Unit)
10 A
Water level
4
Frequency
60 Hz
Agitation frequency
(Normal)
92±2
Motor horsepower
½
Agitation frequency
(Gentle)
61±2
Plug
6-20P
Motor speed
2 speed
Dimensions
Spin speed
(revolutions per
minute)
640 / 473 rpm
Cabinet
Height
−
overall
43-
1
/
4
”
Height of cabinet
36”
Width
26-
7
/
8
”
Depth
28”
Clearance
−
washer lid
23-
1
/
2
”
Weight
Crated
173 lbs.
