15
Connect Vent
1.
Using a 4" (10.2 cm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure the vent is
clean. The dryer vent must fit over the dryer exhaust outlet
and inside the exhaust hood. Make sure the vent is secured
to exhaust hood with a 4" (10.2 cm) clamp.
2.
Using two or more people, move dryer to desired installation
location. Do not crush or kink vent. Make sure dryer is level.
Complete Installation
1.
With dryer in final position, place level on top of the dryer, first
side to side; then front to back. If the dryer is not level, adjust
the legs of the dryer up or down until the dryer is level.
2.
Using a Torx T20 security driver, open the control panel and
rest it on the bottom edge of the opening.
3.
For added security between the upper dryer and the collar,
insert the cotter hair pin through the connecting bolt.
4.
Close the control panel.
5.
Plug in dryer or reconnect power.
6
Check dryer operation.
Select a full heat cycle, let the dryer run for at least five
minutes. Dryer will stop when time is used up.
NOTE:
Dryer door must be closed for dryer to operate. When
door is opened, dryer stops, but time continues to count
down. To restart dryer, close door and reselect cycle.
7.
Now start the dryer and allow it to complete a full heat cycle
to make sure it is working properly.
ELECTRONIC CONTROL SETUP
See Tech Sheet for information on setup.
Maintenance instructions:
■
Clean lint screen after each cycle.
■
Removing accumulated lint:
•
From inside the dryer cabinet:
Lint should be removed every 2 years or more often,
depending on dryer usage. Cleaning should be done
by a qualified person.
•
From the exhaust vent:
Lint should be removed every 2 years, or more often,
depending on dryer usage.
■
Keep area around dryer clear and free from combustible
materials, gasoline and other flammable vapors and liquids.
■
Keep dryer area clear and free from items that would obstruct
the flow of combustion and ventilation air.
If dryer does not operate, check the following:
■
Electrical supply is connected.
■
Circuit breaker is not tripped or house fuse is not blown.
■
Door is closed.
■
Controls are set in a running or “ON” position.
■
Cycle has been selected.
■
For gas dryers, check that gas supply shutoff valves are set
in open position.
If you need assistance:
The Commercial Laundry Support Center will answer any
questions about operating or maintaining your dryer not covered
in the Installation Instructions. Just dial 1-800 NO BELTS
(1-800-662-3587) — the call is toll free.
When you call, you will need the dryer model number and serial
number. Both numbers can be found on the serial-rating plate
located in the dryer door well.
MAINTENANCE INSTRUCTIONS
